RONDELL RDE-1621 Die Betriebsanweisung Seite 19

•
Do not use metal objects that can scratch the non-
stick coating of the bowl (9).
•
Do not leave the plastic soup ladle (12) or the rice
scooper (13) inside the bowl.
Put the food into the bowl (9) following the recommen‑
dations given in the recipe (see «Recipe book»).
Note: Make sure that the level of ingredients and liquids
does not exceed the maximal mark «3» and is not lower
than the minimal mark «1».
General example of loading products
and water (rice is considered as example)
Measure rice with the measuring cup (11) (one
measuring cup is equal to approximately 160 ml or
140 grams of rice), wash it and place in the bowl (9). See
the rice packaging for the necessary amount of water
according to the recommendations of the manufacturer.
There is a capacity scale inside the bowl (9). Add water
up to the required mark according to the selected
amount of rice.
Example: Having poured two measuring cups of
cereals, pour water to the desired mark (approximately
to mark 2) (Fig. 2).
For liquid porridges it is recommended to mix rice and
water in the proportion 1:3.
Place the bowl (9) in the process chamber of the unit.
Make sure that the outer surface of the bowl is clean and
dry, and the bowl itself is installed evenly and is in tight
contact with the surface of the heating element.
Notes:
– full capacity of the measuring cup: 160 ml. Upper
mark: 120 ml.
– make sure that there are no foreign objects, dirt or
moisture in the process chamber and on the bottom
of the bowl (9),
– wipe the outer surface and the bottom of the bowl (9)
dry before use.
– if you steam products, pour water into the bowl (9)
so that boiling water doesn't reach the bottom of the
basket (10). Put the food into the basket (10) and
place it in the bowl (9).
•
Close the lid (3) until clicking.
•
Insert the power cord connector into the connector
socket (8) and the power cord plug into the mains
socket.
BASIC FUNCTIONS OF THE MULTICOOKER
Switching the multicooker on (standby mode)
– After connecting the multicooker to the mains you
will hear a short sound signal. The unit will go into
standby mode. Symbol «‑ ‑ ‑ ‑» will appear on the
display (24).
– Turn on the multicooker by pressing one of the quick
start buttons (18, 19, 21, 26 or 27), while the control
panel (2) will display the current time period of the set
mode and the selected multicooker operation mode.
– The unit will switch to one of the operating modes
set with the buttons (18, 19, 21, 26 or 27) and will be
ready for operation.
Note: pressing each button is accompanied by a sound
signal.
Selecting and starting the cooking program
– To select a cooking program press the button (18)
«Menu».
– Programs are selected in the following sequence
«Porridge», «Fish», «Pilaf», «Stew», «Steam», «Soup»,
«Chicken», «Rice», «Casserole», «Baking». The cook‑
ing program indicators (25) on the control panel (2)
will light up one by one. The programs «Deep‑frying»
or «Frying» are activated only when the corresponding
button (26) or (27) of the control panel (2) is pressed.
– The digital displays (24) will flash and show the
default cooking time.
– After selecting the desired cooking program and set‑
ting the cooking time, the indicators (25, 26, 27) will
flash for 4 seconds.
– After 4 seconds, the cooking program will start, the
digital symbols of the cooking time will light up con‑
stantly, the countdown of the time until the end of the
cooking program will turn on (see the table «Cooking
programs and their duration»).
19