cecotec CECOMIXER EASY Bedienungsanleitung Seite 10

ENGLISH
2. MAIN COMPONENTS
1. Body
2. Tilt support pusher
3. Tilt support
4. Release pusher to remove rods
5. Speed selector
6. Rod holes
7. Mixing rods
8. Kneading rods
9. Bowl
10. Swivel base
11. Bowl slide knob
3. INSTRUCTIONS FOR USE
• Keep pressed the tilt support pusher (2) and lift up the support (3) (Fig. A).
• To place the bowl (9) in the swivel base (10) keep pressed the swivel base and
turn the bowl to the indicated direction.
• Place the rods into the holes.
• VERY IMPORTANT: The rods that have a ring in the edge must be placed in the
hole with bigger diameter of the blender showed with the letter "R". If it is not
like this, there is risk of dough spill.
MIXING RODS (7): For liquid mixes, creams, egg whites, etc.
KNEADING RODS (8): They are designed to knead pastry and light dough.
• Place the rods in the corresponding holes pressing and turning round in order
to have them correctly fixed. Use always the rods together. Never use different
rods together.
• Keep pressed the pusher (2) and move down the tilt support (3) (Fig. A).
• Select the speed with the selector (5).
• It is advisable to begin at the lowest speed (position 1) to then increase the
speed to highest speed (position 6). However, and depending on the texture of
the food, you may use the highest position from the start.
10