Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PPVT750LCD
1. Safety
Safety Information
To ensure safe operation
follow these instructions. Failure to observe wamings
can result in severe injury
- This meter is designed
persons and in accordance with safe methods of
work
- Avoid working alone so assistance
rendered If the operators safety can not be
guaranteed, the Tester must be removed from
service and protected
- Prior to usage ensure perfect instrument function
(e g on known voltage source) before and after the
test.
Do not connect the instrument to vo tages higher
than
750V
- Do not open the battery cover before take off from
voltage source
- The safety can no longer be insured if the
Tester
:
• shows obvious damage • does not carry out the
desired
measurements
ong under unfavorable conditions • has been
subjected to mechanical stress (i.e. during
transport)
- All relevant statutory safety regulations must be
adhered to when using this instrument.
- The Tester may no longer be used if one or several
functions fail or if no functionality is indicated or the
Tester looks damaged
- When using this Tester, only the handles of the
probes may be touched do not touch the probe tips
(metal part).
- Do not use the Tester if the Tester is not operating
properly or if it is wet.
- Use the Tester only as specified in the Instruction
card including
usage in dry environments must be followed or the
protection by the Tester might be impaired.
- Use extreme caution when working around
conductors
or bus
could
result
in an electric
- Use caution
with voltages
110V DC. These voltages pose a shock hazard.
The voltage marked on this meter are nominal
voltages or nominal vo tage ranges and that this
meter is only to be used on insta lations with the
specified nominal voltage or nominal voltage ranges
- ELV indicator
and internal
used for measuring purposes
Verify the meter operation by measuring a known
voltage and by connecting
before use it If no response, replace the battery
first or have
the meter
and service of the Tester,
or death
to be used by skilled
against use
• has been
environmental
conditions
bar. Contact
shock.
above 50V AC rms or
sounder
the test probes together,
services
01
can be
stored
for too
and the
bare
with the conductor
are not to be
Werbung
