Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTION CONTROL UNIT
GB
1. CONTROLS
Button - ON/OFF
Button - LIGHT
Button - MODE
Button - PLUS, MINUS
2. CHANGING THE LANGUAGE
Hold the MODE-button in the standby mode (dark display) for 5
seconds.
Change the language by pressing the PLUS-button.
(German -> English -> French -> Dutch).
Confirm by pressing the MODE-button.
3. LIGHT
Switch the light ON/OFF by using the LIGHT-button. If your cabin
is equipped with an LED spot, you have to switch it on by using
the remote control.
4. SWITCHING ON THE INFRARED CABIN
By pressing the ON/OFF-button the cabin is switched ON/OFF.
Start by pressing the PLUS-button with steamer and the MINUS-
button without steamer.
The infrared cabin starts with the last setting values (the values
remain stored even after a power failure). The evaporator always
starts with 100%.
5. SETTINGS
1 x Mode - Infrared A-radiator1
By pressing the MODE-button (1x) the intensity of „radiator 1" is
adjustable. With PLUS and MINUS the radiation intensity can be
adjusted from 40 to 100 % in steps of 5 %.
2 x Mode - Infrared A-radiator 2
By pressing the MODE-button (2x) the intensity of „radiator 2" is
adjustable. With PLUS and MINUS the radiation intensity can be
adjusted from 40 to 100 % in steps of 5 %.
3 x Mode - Salt evaporator
By pressing the MODE-button (3x) the intensity of the salt evapo-
rator is adjustable. With PLUS and MINUS the evaporator intensi-
ty can be adjusted from 0, 40 to 100 % in steps of 10 %.
4 x Mode - Cabin temperature
Adjustment of the desired cabin temperature from 30 to 60 °C.
At a cabin temperature of 60 °C all radiators are automatically
switched off for safety reasons (at a cabin temperature of 59 °C
they are activated again).
5 x Mode - Surface heating
Adjustment of the desired surface temperature of the surface
heating elements from 30 to 80 °C.
6 x Mode - Running time
Setting of the time with PLUS and MINUS from 10 min to 2 h (in
steps of 10 min.)
Important: The display returns to normal operation after 5 sec.
without pressing a button (on the top right side of the display the
5 sec. are counted down).
6. SWITCHING OFF
Switching off by briefly pressing the
7. RESET TO MANUFACTORY SETTING
If you want to reset to the manufactory settings (operating time:
60 min, cabin temp.: 60 °C, surface heating: 80 °C, infrared A
radiator intensity: 100 %), keep the MINUS+PLUS+MODE-button
pressed at the same time.
The display will show:
ATTENTION !
reset to
manufactory
setting !
ON/OFF
-button.
27
Werbung
