Dangbei Mars Benutzerhandbuch Seite 76

Nota
This equipment has been tested
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance
harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception, which can be determined
off and on, the user is encouraged
- Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced
Changes or modifications
equipment
We declare that this device is in compliance
Satisfies all the technical regulations applicable to the product within the scope of UK Radio Equipment Regulations (SI 2017/1206);
CIK Electrical Equipment (Safety) Regulations (SI 2016/1 101); and UK Electromagnetic
This device operating
5250-5350MHz(EIRP
We declares that this device is in compliance
Satisfies all the technical regulations applicable to the product within the scope of (JK Radio Equipment Regulations (SI 2017/1206);
CA UK Electrical Equipment (Safety)Regulations (SI 2016/1101); and UK Electromagnetic Compatibility Regulations (SI2016/1091).
THIS DEVICE COMPLIES
74
and found to comply with the limits for a Class
However, there is no guarantee that interference will not occur in a particular installation
to try' to correct the interference by one or more of the following measures:
radio/TV technician for help
not expressly approved by the party responsible for compliance
with the essential requirements
with the essential repuirements and other relevant provisions of Directive 2014/53/ElJ.
WITH DHHS RULES 21 CFR CHAPTER
B digital device, pursuant
could void the user's authority to operate the
and other relevant provisions of Directive 2014/53/ElJ
Compatibility
<
13 98dBm)
SUBCHAPTER J
to Part 15 of the FCC Rules
with the instructions, may cause
by turning the equipment
Regulations (SI 2016/1091)
RP < 23dBm),