cecotec POWER RETROGREEN 1200MAX Bedienungsanleitung Seite 17

ENGLISH
Use
1. Attach the balloon whisk to the coupling unit.
2. Attach the coupling unit to the motor unit.
3. Put the ingredients in a large and deep bowl.
4. Fully immerse the balloon whisk in the ingredients. To avoid splashes, start the process at
normal speed.
Food chopper
- The chopper is designed to chop foods such as nuts, meat, onions, cured cheese, hard-
boiled eggs, garlic, spices, stale bread, etc.
- Never let the motor run more than 3 times in a row, let it rest for half an hour.
- Remove any bone inside the ingredients to be processed and cut food into pieces with 1-2
cm thickness.
Use
Warning: the blades are very sharp. Use extreme care when handling the blades unit. Take
special care when removing the blades unit from the chopper container, when emptying the
chopper container and during cleaning.
1. Insert the blades into the chopper container.
2. Then, put the ingredients into the container.
3. Place the chopper coupling in the container.
4. Attach the motor unit to the chopper coupling and turn it until it locks into place.
5. Press the Normal speed or the Turbo speed button to switch on the appliance.
- If the ingredients stick to the wall of the container, remove them by adding liquid or using a
spatula. Always allow the appliance to cool down after mincing meat.
Comparison table
Food type Maximum amount (g)
Meat (20 mm cubes) 250
Vegetables 100
Nuts 150
Garlic 150
Bread 80
POWER RETRO 1200MAX / POWER RETRO 1200MAX CREAM&CRUSH
Time (s)
Less than 20
10
15
15
10
Pepper 50
Quartered onion 200
Seedless fruit 200
Raisins + honey 60 + 55
These data are approximate and depend on many different factors.
4. CLEANING AND MAINTENANCE
- Unplug the appliance from the mains and allow it to cool down before cleaning.
- After grinding too salty food, you must rinse the blades with water immediately.
- Use a soft damp cloth to clean the outside of the appliance.
- Do not use too much cleaning or descaling agent.
- Never immerse the appliance in water or any other liquids.
- Do not use sponges, powders or abrasive cleaning agents to clean the appliance.
- Handle the blades with care since they are extremely sharp.
- After grinding coloured food, the plastic parts of the appliance may become discoloured. It
is advisable to clean these parts with vegetable oil before washing or putting them in the
dishwasher.
Cleaning the blades
To clean the blending shaft properly, place 300 ml of lukewarm water in the blender jug with
a little dishwashing soap, insert the blending shaft into the soapy water up to the bottom of
the blender jug, and run the blender in turbo mode in 10-second intervals. Empty the contents
of the blender jug and refill it with 300 ml of clean water and repeat the same operation for
rinsing. Repeat this process if necessary. Be cautious of splashes.
5. TECHNICAL SPECIFICATIONS
Product reference: 03945 / 03937 / 03938 / 03939 / 03940 / 03946 / 03941 / 03942 / 03943
/ 03944
Product: Power RetroGreen 1200MAX / Power RetroYellow 1200MAX / Power RetroBlue
1200MAX / Power RetroRed 1200MAX / Power RetroBeige 1200MAX / Power RetroGreen
1200MAX Cream&Crush / Power RetroYellow 1200MAX Cream&Crush / Power RetroBlue
1200MAX Cream&Crush / Power RetroRed 1200MAX Cream&Crush / Power RetroBeige
1200MAX Cream&Crush
POWER RETRO 1200MAX / POWER RETRO 1200MAX CREAM&CRUSH
ENGLISH
10
10
10
10