Etherma LAVA-BASIC 3.0 Montage- Und Gebrauchsanleitung Seite 10

N O T E S
› LAVA infrared heating devices comply with the relevant
®
safety requirements.
› Installation and initial start-up, as well as repairs and servicing,
ual only. All safety regulations must be observed. This person
plies with the relevant standards. The responsibility of the
manufacturer is limited to supply of the device.
›
› Comply with local safety precautions.
› The devices are suitable for the installation on walls and on
ceilings.
› Protective areas must be observed in accordance with DIN
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
C L E A R A N C E S
INSTALLATION AND MINIMUM DISTANCES:
LAVA infrared heating devices have to be mounted so that
®
comply with minimum clearances, in particular to highly com-
bustible objects such as curtains, upholstered furniture, etc.
Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION: Strain of any kind on the surface,
whether from persons or objects leaning against it
or from other forces, must be avoided!
10
NOTE
In case of a ceiling installation, the device must be mounted at
-
NOTE
- In bathrooms, the device must be mounted so that switches or
other regulators cannot be touched by persons in a bathtub or
shower.
NOTE
Due to the low surface temperature at the rear side (up to
50 °C) the infrared heating may also be mounted on wooden
panelling.
NOTE
The device is not intended for the use in wardrobes and
beneath church benches.
35 mm
Dimensional drawing: minimum mounting clear-
35 mm
35 mm
35 mm
ances