VEVOR NL30 Bedienungsanleitung Seite 10

Issues
Refrigerator does
not work
Refrigerator
compartments
are too warm
Food is frozen
There is"water flow"
noise from inside the
refrigerator
There are water
drops around the
refrigerator casing
or door gap
The compressor is
slightly noisy when
starting
Code F1displayed
Code F2 displayed
·Check if the switch is on.
·Check if the plug and socket are connected well
·Check if the fuse has been burnt.
Check if the power supply is malfunctioned
·Switch on/off the fridge frequently may cause start
delay of the compressor
·The door is opened frequently.
·A large amount of warm or hot food was stored
recently
·The refrigerator has been disconnected for a long
time
·The temperature was set too low
·It's a normal phenomenon,caused by the flow of
refrigerant.
·It's a normal phenomenon,the moisture will
condense to water when it touches a cold surface of
the refrigerator.
It's a normal phenomenon,the noise will be reduced
after the compressor works stably
·Possible cause:low voltage to fridge.
Adjust the battery protection from High to Medium
or from Medium to Low
·Possible cause:condenser fan is overloaded.
Disconnect power to fridge for 5 minutes &re-start.
If the code shows again,contact manufacturer for
service
- 9 -
Cause/Suggestions