Farmex HT-PRO Bedienungsanleitung Seite 3

GENERAL OPERATING INSTRUCTIONS
1. Install battery. A 9-volt alkaline battery must be connected before
2. To test moisture, press the button above the water drop symbol.
3. To test temperature, press the button above the "Thermometer"
4. To turn display backlight on or off, press the button above the
5. To power off, press and hold the moisture button. Alternatively,
WARRANTY
The HT-PRO moisture and temperature tester carries a one year
manufacturer warranty for materials and workmanship. The warranty
is valid for 12 months from the date of purchase on the receipt. To
claim the warranty, the customer should return the defect product
to the Manufacturer or reseller. The warranty claim must be
accompanied by the description of the fault, copy of sales receipt and
customer's contact information.
product and return it as soon as possible. The liability of Farmcomp
is limited to the price of the product in maximum. The warranty does
not cover any damage that is caused by incorrect or careless use of
the product, dropping the product or damage that is caused by repairs
that are carried out by non-authorized personnel.
or consequential damages that are caused by the use of the product or
the fact that the product could not be used. The battery is not covered
by the warranty. All information, illustrations and specifications in this
manual are based on the latest information available at the time of publi-
cation. The right is reserved to make changes at any time without notice.
OPERATING NOTES
1. Your HT-PRO will read hay moisture between 8.0% and 45%
99209111_Farmex_HT-PRO_manual_all_languages_2023.indd 3 99209111_Farmex_HT-PRO_manual_all_languages_2023.indd 3
EN
the tester will work. Remove the battery door on the back of the
handle and snap the leads onto the battery.
NOTE: Upon power-on, your HT-PRO will shortly display its
firmware version before measuring.
NOTE: Battery symbol will appear in the display if the battery is
running low and needs replacing.
NOTE: The battery must be ALKALINE.
symbol. The tester will display the temperature in Fahrenheit (°F),
or Celsius (°C). To switch between °C and °F, press and hold the
temperature button.
"Light Bulb" symbol during measurement. Your HT-PRO will retain
its backlighting mode (on or off) until changed by the operator
(even if the battery is removed).
wait a few minutes and the HT-PRO will shut off automatically.
The Manufacturer service partner will repair or replace the defect
Farmcomp does not accept any responsibility for any direct, indirect
water of bale weight. The tester is most accurate from 10% to30%.
Readings over 30% should only be used as a qualitative indication
of very high moisture.
3
28.2.2023 7.54.06 28.2.2023 7.54.06