Werbung
In most cases, the vehicle will be able to start immediately after the jump starter has been connected. lf
the vehicle does not start immediately, please ensure the battery clamps have good contact with the
battery terminals and try again. Do not attempt to start a vehicle more than five times within a 15
minute period.
2.1.5 Please remove the jump-start clamps from the car battery immediately after starting. Press the
"Power button
seconds, the product will automatically shut down.
0
A 12v
2.2 Method Two: Forced Start
(SAFETY REMINDER: When using forced start mode, the anti-sparking function and some safety
protection mechanisms are disabled. Be sure to connect to the positive and negative poles correctly.
Failure to do so when using forced start mode will cause a short-circuit condition that may result in
damage to the vehicle, Lokithor or both. Please read and thoroughly understand the instructions in the
manual before using forced start mode. Use due caution when activating and using forced start mode.)
If the auto start feature fails to detect the vehicle battery, use forced start mode. Please strictly follow
the following steps to use the forced start, otherwise this function will not work properly;
Step 1: Connect the jump starter clamps to the EC5 connector on Lokithor.
Step 2: Connect the RED(+) positive clamp to the vehicle battery's positive terminal. While the
device is on, press and hold the "
indicator" will light up, showing the clamps is active.
Step 3: Connect the black (-)negative clamp to the vehicle battery' s negative terminal. Ensure the
connections are secure. The jump starter's overall voltage, now connected in parallel with the vehicle, will
display on the screen. Then start the vehicle.
After jump-starting successfully, press the "
3. Battery Clamp Connection Status (ConnectMax)
In auto start mode, when the clamps are connected to the vehicle battery, a 10-second countdown
begins while Lokithor is checking the battery and connection. If the connection impedance is low, the
clamp status indicator is green. If the connection impedance is high, the clamp status indicator is yellow.
You can adjust the clamp connection during the countdown. After 10 seconds, you must exit the
jump-start mode and make a new clamp to terminal connection to re-measure the connection
impedance.
When Lokithor is in forced start mode, the clamp status indicator always flashes yellow to advise caution
during use.
4. How to use the voltmeter function
4.1 Connect the clamps to Lokithor.
4.2 Connect the red(+) clamp to the positive(+) terminal of the battery and black(-) clamp to the
negative(-) terminal on the battery, and make sure the connections are secure.
4.3 After the 10-second countdown for detection ends, the "start indicator" on the main interface lights
up and displays the current battery voltage of the vehicle.
4.4 Disconnect the clamps from the vehicle battery to exit the voltmeter function mode.
" for 2 seconds to power off the jump starter. lf there are no operations for 60
" for 5 seconds to activate forced start mode. The "Start
" or "Power button
" to exit.
Werbung
