Werbung
0
A 12v
5. How to use LED Lights
1. Long press the "LED Light button
2. Cycle through the LED light modes by pressing the "LED light button
steady on, strobe, SOS, and off.
3. Press and hold the "LED light button "
6. How to charge your jump starter
Tools: Power adapter (PD2.0/PD3.0), USB-C to USB-C wire, USB-A to USB-C wire.
Connect the USB wire's A end to the power adapter and the C end to the product's USB-C charging port.
When the screen's power indicator lights up, it means the product is charging properly.
If the product has low or no power, charge it promptly to avoid low battery voltage.
Do not leave Lokithor in a discharged condition for extended periods. This may cause a condition that
will prevent Lokithor from charging.
7. How to use the 5V USB-A port to charge your mobile phone
Tools: USB-A to USB-C wire, mobile phone.
Connect the USB wire's A end to the product and the C end to the phone's Type-C charging port to start
charging.
8. Error Codes Display
ERROR
NO.
CODE
1
2
3
4
5
6
430
7
450
J1350
1350A 12v
" for one second to turn on the LED light.
Illustration
Over Temperature Protection
Low Temperature Protection
Abnormal Fault
Clamps Reversed
Charging Reminder
External Battery Voltage
Exceeds Device Voltage
Automatic start failed
" for 2 seconds to turn off the LED light.
Reason/Solution
Wait for the product to cool down
Use the product in a suitable
temperature environment
Restart the product /
Contact After-Sale service
Connect to the battery correctly
Current jump-start capacity is insufficient,
please charge and try again
Please charge and try again or check if device
connected to a 24V battery
Confirm correct connections and use
manual start as outlined in the instructions
" briefly. The modes include
Werbung
