Herunterladen Inhalt Inhalt Diese Seite drucken

Ronix RP-0102C Bedienungsanleitung Seite 23

Inhaltsverzeichnis
Verfügbare Sprachen

Verfügbare Sprachen

TROUBLESHOOTING
Disconnect from the electrical power supply before carrying out user
maintenance of checking is correct functioning. To avoid unnecessary
disappointments, you should check the following before contacting the
service organization.In case problems other than the above occur, please
contact your local distributor.
Symptom
Machine refuses to
start
Fluctuating pressure
Machine stops
Fuse blows
Machine pulsating
Machine often starts
and stops by itself
Machine starts, but
No water comes out
Cause
- Machine not plugged in
- Defective socket
- Fuse has blown
- Defective extension
cord
- Pump sucking air
- Valve is dirty, worn out
or stuck
- Pump seals worn out
- Fuse has blown
- Incorrect mains voltage
- Thermal sensor acti-
vated
- Nozzle partially
blocked
Fuse too small
- Air in inlet hose Inad-
equate supply of mains
water
- Nozzle partially
blocked water filter
blocked
- Hose kinked
Pump/spray gun is
leaking Center
- Pumpt/hoses or
accessory frozen
- No water supply
- Water filter blocked
- Nozzle blocked
Recommended Action
- Plug in machine
- Try another socket
- Replace fuse
- Switch off other machine
- Try without the extension cord
- check that hoses and connections are airtight
- Clean and replace or refer to local distributor
- Clean and replace or refer to local distributor
- Replace fuse
- Switch off other machines
- Check that the main voltage corresponds to
specification on the model tag
- leave the washer for 5 minutes to cool down
- Clean the nozzle
- change to an installation higher than the amp
consumption of the machine
- You may try without the extension cord
Allow machine to run with open trigger until
regular working pressure resumes
- Check the water cupply corresponds to
specifications required
- Avoid using long, thin hoses (min. 1/2:")
- Clean the nozzle
- Clean the filter
- Straighten out hose
Contact your nearest Service
- Wait fir Pump/hoses or accessory to thaw
- Connect inlet water
- Clean the filter
- Clean the nozzle
21
User Manual
Inhaltsverzeichnis
loading

Inhaltsverzeichnis