Ronix RP-0102C Bedienungsanleitung Seite 20

4. Connect the garden hose to the water inlet
Connect the garden hose adaptor(female coupler) to the water inlet of
the pressure washer, then thread your garden hose(male end) into the
garden hose adaptor.
NOTE:
The machine not suitable for connection to the potable water main.
WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 7 bar .
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
Check the electrical supply voltage and frequency (Volt/Hz) correspond
to those specified on the washer rating plate. If the power supply is
correct, you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds to
allow air to escape and discharge residual pressure in the hose.
18
Compact Induction High Pressure Washer 100bar- 1200W