KingSlim D1 PRO Kurzanleitung Seite 8

4. Firstly clean the windshield with a dry cloth, secondly put and press the
suction cup on the windshield to make sure there is no air inside the
suction cup, finally rotate to fix the suction cup. (Note: When installing,
please don't let the rearview mirror block the camera's infrared light.)
5. Adjust the viewing angle of the dash cam to get a good view.
6. Connect the car charger to the car cigarette lighter, then insert the USB end
of the charger into the USB power port of the dash camera, please refer to
the below picture.
7. Attach the GPS electrostatic sticker to the top edge of the windshield, and
then fix the GPS module on the electrostatic sticker, please refer to the
below picture.
8. Fix the cable with a cable clip at the place where the icon is (please refer
to the below picture), then use the yellow crowbar to hide the cable.
Note:
1. After the dash cam is plugged in properly, it will automatically turn on and start
recording (if the card has been inserted). To change settings, please firstly stop
recording.
Cable clip
06
GPS
Electrostatic Stickers