Vulpes Goods CALLUS REMOVER Anleitung Seite 5

Protector
Always keep the protector in place during use. Without the
protector, too much dust can get into the remover, which
could damage the device.
Sanding Bit
Choose the correct sanding bit before you start. Each
sanding bit has a different coarseness, which affects the
result. Do not use the sanding bit on the same spot for
more than 5 seconds to avoid irritation.
Charging Port
Use the provided cable to charge the callus remover.
Charge the device for at least 2 hours, but no longer
than 12 hours. When fully charged, the indicator will show
100%.
On/Off/Control
Press the button once to turn on the callus remover. Press
twice to switch to the second speed. Press three times to
turn off the device.
Indicator
The indicator shows the battery level and the selected
mode.
5
COPYRIGHT @ ALL RIGHTS RESERVED BY VULPES GOODS®