Amazonas KOALA Montageanleitung/Benutzer- & Sicherheitshinweise Seite 8

IMPORTANT! READ
CAREFULLY AND KEEP FOR
FUTURE REFERENCE.
Assembly instruc� ons:
A) Fold out the side parts of the stand (with the rubber feet facing downward!) and set
up in accordance with the illustra� ons.
B) Hang the baby hammock (with wooden expansion struts) into the hook in the eye
bolt.
i
C) Install the safety harness system under the hammock in accordance with the illus-
tra� ons. Make sure that the two horizontal belts which grab around the ground struts
are fi rmly � ghtened. The belts directly under the hammock can be adapted to the
height of the hammock and should be slightly taut in order to limit the rocking mo� on.
D) Adjus� ng the Depth of the Hammock
!
• Open press-stud on the corner of the baby hammock and uncover the wooden
rod.
• Push back the hammock material, so that the knot becomes visible. Loosen knot
and pull the cord outwards through the slit in the wooden rod, un� l the desired
gathering is achieved.
• Tighten the knot again and close press-stud.
• Repeat process on all four corners.
• Result: hammock hangs lower.
-> If a fl a� er surface for lying down is desired on the hammock, the cord must
be shi� ed inwards a� er loosening of the knot.
E) Use of the restraint system as shown in the illustra� on
Always use the complete restraint system. Lap belt and crotch belt must be used cor-
rectly. Make sure that the seat belt is not loose or twisted. There should always be 1
fi nger width between the harness and the baby so that the restraint system is neither
too loose nor too � ght and secures your child well.
EN
AMAZONAS ® KOALA