Ronix RP-0140 Bedienungsanleitung Seite 25

- Fuse has blown
- Incorrect mains
voltage
Machine stops - Thermal sensor
activated.
- Nozzle partially
blocked
Fuse blows Fuse too small
- Air in inlet hose
Inadequate supply of
mains water
Machine pul-
- Nozzle partially
sating
blocked water filter
blocked
- Hose kinked
Machine often
Pump/spray gun is
starts and stops
leaking Centre
by itself
- Pump/hoses or
Machine starts, accessory frozen
but no water - No water supply
comes out - Water filter blocked
- Nozzle blocked
- Replace fuse
- Switch off other machines
- Check that the main voltage corre-
sponds to specification on the model
tag.
- Leave the washer for 5 minutes to
cool down
- Clean the nozzle
- Change to an installation higher
than the amp consumption of the
machine.
- You may try without the extension
cord
Allow machine to run with open
trigger until regular working pressure
resumes
- Check the water supply corre-
sponds to specifications required
- Avoid using long, thin hoses
(min1/2")
- Clean the nozzle
- Clean the filter
- Straighten out hose
Contact your nearest Service
- Wait for Pump/hoses or accessory
to thaw
- Connect inlet water
- Clean the filter
- Clean the nozzle
23
User Manual