Ronix RP-0140 Bedienungsanleitung Seite 20

- Connect the high pressure hose to the water outlet on the washer.
- Connect the water supply hose to female coupler. Then connect to
the water inlet of the washer. The supply hose must have an internal
diameter of at least 13mm (1/2 in) and must be reinforced. the water
supply must be at least equal to the washer delivery capacity.
WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 0.7 MPa.
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
18
Induction High Pressure Washer 140bar
Outlet