Ronix RP-0140 Bedienungsanleitung Seite 18

cause injury to body.
- In the event of accident or breakdown, switch off the machine immediately.
(e.g. contact with detergent: rinse with an abundance of clean water.
ATTENTION:
Through poor conditions of the electrical MAINS, shortly voltage drops
can appear when starting the EQUIPMENT. This can influence other
equipment (e.g. Blinking of a lamp). If the MAINS-IMPEDANCE Zmax <
0.335 OHM, such disturbances are not expected. (In case of need, you
may contact your local supply authority for further information.)
WARNING!
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment grounding conductor can result
in a risk of electrical shock. Check with a qualified electrician or service
person if you are unsure if an outlet is properly grounded. DO NOT
modify the plug provided with the appliance to fit an outlet, have a proper
outlet installed by a qualified electrician.
MAINS POWER CONNECTION
The following should be observed when connecting the high pressure
washer to the electric installation:
- The electric installation shall be made by a certified electrician and
comply with IEC-364.
It is recommended that the electric supply to this appliance should
include either a residual current device that will interrupt the supply if
the leakage current to earth exceeds 30mA for 30ms.
IMPOTANT:
Only use water without any impurities.
- Safety devices
- If there is a risk of running sands in the inlet water (i.e. from your own
well), an additional filter should be mounted.
16
Induction High Pressure Washer 140bar