Ronix RP-0140 Bedienungsanleitung Seite 24

- Clean the nozzle with the tool provided. Remove the lance from the
gun; remove any dirt from the nozzle hole.
TROUBLESHOOTING
Disconnect from the electrical power supply before carrying out user
maintenance or checking is correct functioning. To avoid unnecessary
disappointments, you should check the following before contacting the
service organization.
In case problems other than the above occur, please contact your local
distributor.
Symptom
Machine refus-
es to start
Fluctuating
pressure
22
Induction High Pressure Washer 140bar
Cause
- Machine not plugged
in
- Defective socket
- Fuse has blown
- Defective extension
cord
- Pump sucking air
- Valve is dirty, worn
out or stuck
- Pump seals worn out
Recommended Action
- Plug in machine
- Try another socket
- Replace fuse
- Switch off other machine
- Try without the extension cord
- Check that hoses and connections
are airtight
- Clean and replace or refer to local
distributor
- Clean and replace or refer to local
distributor