Pro-Ject Audio Systems Stereo Box E Bedienungsanleitung Seite 5

•
Close the battery case cover
Battery type: 2x AAA 1,5V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Stereo Box S3 BT
Power output:
Frequency response (20Hz-20kHz):
Channel separation:
Signal to noise ratio Variable output:
THD:
Gain:
Phono MM input:
Line level inputs:
Line input sensitivity:
Line input impedance:
BT version:
BT music receiver codec:
BT maximum TX power:
Speakers connectors:
Outboard power supply:
Power consumption in standby:
Replacement battery remote control:
Dimensions: WxHxD (D with sockets):
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright 2024. All rights reserved.
©
Waste from Electrical and Electronic Equipment (WEEE): This directive mandates the collection and recycling
of electronics and component materials in order to reduce the amount going to landfills. Outside North
America, when the user decides to discard this product, it must be sent to a separate collection facility for
recycling. Please contact your point of purchase for more details.
2x 21W/40W at 8 ohms/4 ohms (1% THD)
< (-0,3dB; -2.5dB) at 4ohm
60dB @ 1kHz
90dB 'A' weighted
< 0,12% at 5W / 4 ohms
25dB
1 x RCA with grounding screw
1 x RCA, 1 x 3.5mm
700 mV
20 kohms
5.0
aptX, aptX HD, A2DP profile
+9dBm
 4mm banana plugs, spades connectors or naked wire
20V/3A DC, suitable for your country's mains supply
<0.5W
2x AAA 1,5V
206 x 51 x 115 (186) mm
2kg without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Pro-Ject Audio Systems · Stereo Box E · Revision 31.05.2024
5