Safety Measures - Rondell Rde-1005 Die Betriebsanweisung

KETTLE RDE-1005
The liquid heating appliance (kettle) is intended for boiling
drinking water only.
DESCRIPTION
1. Kettle body
2. Kettle spout
3. Lid
4. Lid handle
5. Kettle handle
6. Display
7. Water level scale
8. Base
9. Cord storage
10. Temperature selection button
11. Power button
12. Keep Warm mode indicator
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal operation
current not exceeding 30 mA, to install RCD, contact
a specialist.

SAFETY MEASURES

Before using the unit, read this manual carefully and keep it
for future reference.
Use the unit for intended purposes only, as specified in this
manual. Mishandling the unit can lead to its breakage and
cause harm to the user or damage to his/her property.
•
Use the unit for its intended purpose only and in strict
accordance with the instruction manual.
•
Make sure that your home mains voltage corresponds to
the voltage specified on the unit body.
•
The power cord is equipped with a «europlug»; plug it into
the socket with a reliable grounding contact.
•
To avoid the risk of fire, do not use adapters for connect-
ing the kettle to the mains.
•
Do not use the kettle in bathrooms. Do not use it near
swimming pools or other containers filled with water.
•
Do not use the kettle near heat sources or open flame.
•
Do not use the unit in places where aerosols are sprayed
or highly flammable liquids are used.
•
Do not use the kettle outdoors.
•
Do not leave the operating kettle unattended.
•
Place the kettle on a flat stable surface; do not place the
kettle on the edge of the table.
•
Do not direct the kettle spout at wooden furniture, elec-
trical appliances, books and objects which can be dam-
aged by moisture, hot steam.
•
Before switching the kettle on, make sure that it is placed
on the base evenly.
•
Use only the base supplied with the unit.
•
Do not let the power cord hang from the edge of the table
and make sure it does not touch hot surfaces or sharp
edges of furniture. You can adjust the power cord length
by winding it around the base.
•
Do not touch the power cord and the power plug with
wet hands.
•
Do not switch the kettle on if it is empty.
•
Do not fill the kettle with water when it already stands
on the base.
•
Be careful when using the kettle to avoid getting liquid on
the electric connector of the kettle.
•
Do not use the kettle if the lid is not closed tightly.
•
Take the kettle off the base before opening the lid.
•
Use the kettle only for boiling drinking water, do not heat
or boil any other liquids.
•
Ensure that the water level in the kettle is not below the
minimal mark «MIN» and not above the maximal mark
«MAX». If the water level exceeds the maximal mark,
boiling water can splash out of the kettle during boiling.
•
Provide that no water gets on the display or touch but-
tons.
•
To avoid burns by hot steam, do not bend over the kettle
spout while it is operating.
•
Do not open the kettle lid while water boiling. Be care-
ful when opening the kettle lid immediately after boil-
ing water.
•
Do not touch hot surfaces of the kettle, take it only by
the handle.
•
Be careful, the kettle heating element surface remains
hot for some time after use!
•
Be careful while carrying the kettle filled with boiling
water.
•
Do not remove the operating kettle from the base. If it is
necessary to remove the operating kettle, first switch it
off by pressing the button
the touch buttons and the display to be switched off and
then remove the kettle from the base.
•
Unplug the kettle base before cleaning and when you are
not using the kettle. Never pull the power cord when dis-
connecting the base from the mains; take the power plug
and carefully remove it from the mains socket.
9
, wait for the backlight of