i.safe MOBILE IS440.1 Bedienungsanleitung Seite 5

Do not expose the device to aggressive acids or bases.
Protect the device and the Power Adapter from strong electrical magnetic fields as for examp-
le those emitted by induction cookers or microwave ovens, for example.
Only use accessories approved by i.safe MOBILE GmbH.
Do not open the device or carry out any repairs yourself.
Do not use the device in places where its use is prohibited.
Turn off the device in clinics or other medical facilities.
Always keep a safety distance of at least 15 cm between the device and a pacemaker or
hearing aid. The device can affect the functioning of medical devices such as pacemakers and
hearing aids.
When using the device while driving a motor vehicle, be sure to comply with applicable
national laws.
When using earphones or headsets at the maximum volume setting, first set the volume
control on the device to 50 % of the maximum volume. Gradually adjust the volume.
Do not charge the device in the vicinity of flammable substances.
Only charge the device using the charging equipment approved by i.safe MOBILE GmbH.
Only charge the device at ambient temperatures between 0 °C to +45 °C (+32 °F to +113 °F).
Only charge the device under dry indoor conditions.
Do not charge the device in environments dusty or humid.
Do not touch the display with sharp objects.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood Operating Manual, Safety Instructions and certificate.
When used in explosion hazardous areas, the following Safety Instructions must also be
complied with:
Inside explosion hazardous areas the USB interface must be closed.
Within explosion hazardous areas, the following accessories may be used when connected to
the ISM interface:
-
the Headset IS-HS3A.1
-
the Headset IS-HDHS2x.1
-
the Headset IS-HDHS1x.1
-
the PTT Button IS-PTTB2A.1 together with the Headset IS-HDHS2x.1 or IS-HDHS1x.1
-
the PTT Button IS-PTTB2A.1 without Headset IS-HDHS2x.1 or IS-HDHS1x.1
-
other accessories approved by i.safe MOBILE GmbH.
If the PTT Button IS-PTTB2A.1 is connected to the 8-pin ISM interface of the device together
with the Headset IS-HDHS2x.1 or IS-HDHS1x.1, the connection between the IS-PTTB2A.1
and the Headset IS-HDHS2x.1 and IS-HDHS1x.1 can be disconnected and reconnected in
explosion hazardous areas.
When using the IS-PTTB2A.1 without the Headset IS-HDHS2x.1 or IS-HDHS1x.1, the unused
cable end of the IS-PTTB2A.1 may remain open in explosion hazardous areas.
When using accessories with Velcro fasteners (e.g. Headset IS-HDHS1B.1), the Velcro fastener
may only be adjusted outside explosion hazardous areas.
EN
5