Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Valve connection:
Make sure that the rocker arm of the valve head (on the hose) is
closed when connecting to the tire valve before starting the pumping
process. Otherwise no pressure can be built up.
To remove the valve head from the tire valve, the rocker arm must be
opened again. The valve head should be removed from the tire valve
immediately so that too much air does not escape from the tire.
Air pressure display: When the valve head (on the hose) is connec-
ted to the tire valve and the rocker arm is closed, the current actual
tire pressure is displayed. If you press the "+" or "-" button once, the
preset target air pressure is displayed. This display flashes for several
seconds and then switches back to displaying the actual air pressure.
By pressing or holding down the "+" or "-" button several times, you
change the target air pressure. This setting is retained after the device
is switched off.
Pumping process:
When switched on, the pumping process is started by simply pressing
the power button
started.
The pumping process ends when the previously set air pressure is
reached. If you want to stop the pumping process, simply press the
power button
.
Deflate:
If air needs to be released from the tire, all you have to do is open the
rocker arm of the valve head (on the hose). This way air escapes from
the tire. Closing the rocker arm again stops the air escaping and the
current tire pressure is displayed on the device.
Werbung
