Assembling The Cabin; Mounting The Feet; Assembling The Barrel Staves; Assembling The Front And Rear Wall - Sentiotec Kaski 240 View Canopy Montageanleitung

Installation instructions

2. Assembling the cabin

ATTENTION!
Note the floor plan on page 10 and illustrations from page 9 onwards.

2.1. Mounting the feet

Place the impregnated feet[1,33] on the foundation (see page 9) as shown in the
illustration (see page 12). Fix them temporarily with two staves[3].
Make sure that the feet are fitted parallel to each another.
Note the power supply!

2.2. Assembling the barrel staves

Start by placing the lower stave[2] in position (with drain – see page 13).
Always put the staves together with the round part facing upwards.
Lay five staves to the left[3a] and five to the right[3b] and screw to the feet.
Make sure that there is no visible gap between the staves.

2.3. Assembling the front and rear wall

Connect the individual parts of the front wall[7a,b,c,d, 31] (see page 14).
Place the walls in the groove of the staves. Check the vertical alignment with the
spirit level and provisionally fix in place with two staves.
CAUTION - GLASS BREAKAGE!
For the glass element[8], the screws must ONLY be screwed in flush -
countersunk screws can cause the glass to break.
For the lighting, secure the wooden strip[12] centrally on the rear wall.

2.4. Completing the barrel

Fit the remaining staves. Fix these to the front and rear wall using screws.
Closing the barrel: Use whatever is required from the supplied filler set
(= staves[4] with strips[5,6]).
Mount the tensioning bands[24] (see page 19).
Note that the tension rods[23,25,26,27] are positioned in the lower half
of the barrel sauna.
p. 7/8
EN