WAGNER FURNO 500 Bedienungsanleitung Seite 5

FURNO 500
• Keep the appliance and its cord out of reach of children aged less
than 8 years.
MAINS CONNECTION (UK only)
This Heat Gun has been supplied with a fused cordset. This is identified
by the fuse holder in the base of the plug. Please read the following
safety instructions before use:
1. If the cordset is damaged replace with a new cordset to avoid
a safety hazard. Please contact Wagner customer services for a
replacement cordset.
2. NEVER under any circumstances use the Heat Gun or cordset
without the fuse cover fitted. This is the little cover fixed into the
base of plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer
for a replacement or ring our helpline.
4. A replacement fuse must be rated at 13 Amps. This must be
manufactured and approved to BS1362.
5. IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
MAINS CONNECTION (Non-UK)
This Heat Gun has been supplied with a cordset. If the cordset is
damaged replace with a new cordset to avoid a safety hazard. Please
contact Wagner customer services for a replacement cordset.
IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
WARNING - Use an extension cord that will accept the plug on the
product. Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. A
harmonised H05RR-F 3 x 1.0sq mm rubber type cord is required as a
minimum for general use.
Protective Cap
WARNING - Remove plastic cap and
discard before using your heat gun.
Using the Heat Gun
General Description
This Heat Gun is a quality power tool. Like any power tool, it can be
dangerous when misused. Read the following instructions carefully and
follow all safety precautions. It is the responsibility of the owner to use
the Heat Gun properly.
Specifications
Housing Engineered high-impact corrosion and heat-
resistant polymers
Wattage 2000 Watts on HIGH, 150 Watts on LOW
Voltage 220 - 240 V a.c.
Frequency 50 - 60Hz
Heat Output Approximately 600°C on HIGH, approximately
60°C on LOW
Weight 0.9 kg
EN
5