Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Start the walk:
1 Power button
With the skateboard turned off, press the on/off button for 3 seconds
to turn the skateboard on/off.
2. Modes of operation
With the skate on, press the display button once to switch between
the 3 speed modes. There is also a PEDESTRIAN mode: in this mode
the scooter can reach 6 km/h for safety reasons in busy places. A
short double press on the display button will turn the lights on and
off.
3. If you want to use the turn signals, press the buttons on the handle -
bars near the bell.
Battery and Charger:
Each smartGyro is equipped with a lithium battery and its charger, it
also has its own serial number that you can find on the chassis and
skate plate. Do not replace the battery or its charger, it could be
dangerous.
Lithium battery
Please fully charge the battery before using your smartGyro Z-PRO.
Charge the battery when its level is at the middle of the energy bar
to prevent it from influencing your driving.
Instructions for loading:
1. Connect the charger plug to the mains.
2. Important: Plug the charger into a 100V-240V power outlet.
3. Red light: charging. Blue/green light: charging process completed.
Please always store the charger in a dry and ventilated environment.
15
Werbung
