Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
before first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Clean the glass with a damp cloth. Check that the voltage in your
home corresponds with the voltage printed on the bottom of the appliance. Follow the installation instructions in chapter 7
for installing the hob.
SAFETY PROVISIONS
Pan detection mode
With the pan detection mode, the appliance does not work if you use an unsuitable pan or if the appliance does not detect a
pan on a cooking zone. The operation indicator shows U and it is not possible to increase the power level.
Residual heat indicator
After stopping the appliance, the cooking zones stay hot. If you touch a hot cooking zone this may result in injury.
The operation indicator shows H to indicate the cooking zone is hot. When the cooking zone is cool, the operation indicator
no longer shows H.
4
operation of the appliance
The appliance has electronic sensors that activate when you touch the buttons on the control panel.
The appliance makes a sound when a control is touched.
Caution:
Only use pans that are suitable for an induction appliance. Refer to section Cookware.
PREPARING FOR OPERATION
1. Clean the appliance before operation. Use a damp cloth.
MAXIMUM POWER
The appliance has a maximum power of 3500 watts. The power will be divided between all four cooking zones. It is possible
that the maximum available power for the cooking zones together is exceeded. This can cause switching of the power
between the cooking zones. In that case, the power of the second cooking zone will be decreased automatically. When you
use three or four cooking zones at once, the power level will decrease even further down.
The corresponding operation indicator will flash to show necessary power reduction. It flashes for 3 seconds and during that
time further adaptations of the setting are allowed before the power is automatically reduced.
NOTE: when you have one cooking zone on power level 9, you can add a second cooking zone on maximum power level 8.
When another cooking zone is added, the power levels of the other two cooking zones will further decrease.
STARTING THE APPLIANCE
1. Touch the on/off button to start the appliance. The indicators show "-"/ "--".
Note:
If you do not select a cooking zone within 1 minute, the appliance automatically switches off.
USING A COOKING ZONE
Selecting a cooking zone
1. Put a pan on the cooking zone.
2. Touch the selection button of the cooking zone.
3. Touch the slider to increase and decrease the power level. The operation indicator shows the set power level.
Note :
If you do not select a power level within 1 minute, the appliance automatically switches off.
Stopping a cooking zone
1. Stopping the cooking zone can be done with this procedure:
• Touch the slider to decrease the power level to 0.
Note :
• The operation indicator shows H to indicate the cooking zone is still hot.
• Always lift the pan off the appliance, do not slide it, or it may scratch the glass.
17
English
•
Werbung
