Franke Mythos Water Hub Bedienungsanleitung Seite 16

EN
CO₂ cylinder installation ("Installation
manual", page 12)
1. Remove the protective cap from the CO₂
cylinder, tilt the CO₂ connection forward and
screw the CO₂ cylinder into the CO₂ pressure
reducing valve by turning it to the right until it
cannot be tightened any further. Tilt the CO₂
connection backwards.
Notice: The CO₂ cylinder must be thoroughly
tightened so that a tight seal is formed. Some
gas may escape, and a hissing noise may be
heard. Keep tightening, until it can not get any
further. No more gas should be heard escaping.
Tap operation
Operation of the electronic knob
▶ The electric knob in standby mode doesn't react
on rotary movement.
▶ To activate the electronic knob press briefly 1x
(fig. 1).
1
▶ Turn forward or backward the electronic knob to
choose desired kind of water - LED color is
changing with the move (fig. 2).
2
2. After the CO₂ cylinder is assembled, the LEDs on
the user interface will light up switching from red
to green.
3. Install the front cover.
4. The unit cools down and heats up for approx.
25 minutes, after which the device is ready for
use.
Notice: The final carbonation quality will be
established after using the product for a few
days.
▶ For continuous flow of chosen water hold
electronic knob pressed (fig. 3).
Deactivation: Release the knob.
3
▶ For chosen amount of water 0.5, 1 or 2 liters press
briefly the electronic knob according to the
information in the table below (fig. 4).
Deactivation: Press briefly 1x.
4
2x / 3x
▶ Hold the object to be filled close to the tap so that
the object surrounds the delivery opening of the
tap. This will prevent water from splashing.
16