Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.4
Using the dust bag (Fig. 6)
▪
Insert the dust bag (4) into dust extraction port, make sure the dust bag is tightly fastened.
▪
Check whether the dust bag (4) is firmly fixed on the dust extraction port by pulling it
gently.
10.5
Changing the speed (Fig. 7)
The rated speed and impact rate can be adjusted just by turning the speed adjusting dial (10).
The dial is marked MIN (lowest speed) to MAX (full speed).
The speed adjusting dial (10) can be turned only as far as 6 and back to 1. Do not force it past
6 or 1, or the speed adjusting function may no longer work.
WARNING: Avoid blocking the vent holes, as this may cause the eccentric
sander to overheat.
WARNING: To prevent accidents, turn off the tool and disconnect its power
supply after use. Clean and store the tool indoors and out of children's reach.
11 TECHNICAL DATA
Rated voltage (DC)
Rotation speed
Sanding surface
Engine type
Oscillation speed
Oscillation width
Soft grip
Hook&loop system
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)
13 CLEANING AND MAINTENANCE
▪
The machine does not require any special maintenance.
▪
For safe and efficient working, always keep the machine and the ventilation slots clean.
▪
Always be sure that the tool is switched off and unplugged before carrying out any work
on the tool.
14 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
Copyright © 2021 VARO
POWDP50400
20 V
6.000 – 12.000 min
Ø125 mm
Brushed
12.000 – 24.000 /min
1.5 mm
Yes
Yes
79 dB(A)
90 dB(A)
4.3 m/s²
P a g e
| 9
-1
K = 1.5 m/s²
www.varo.com
EN
Werbung
