S-idee V913-A Benutzerhandbuch Seite 25

13.TROUBLE SHOOTING DURING FLIGHT
Situation
Receiver status LED blinks
continuously for more than 4
1
seconds after helicopter battery
inserted. No response to control
input.
No response after battery is
connected to helicopter.
2
Motor does not respond to throttle
3
stick, receiver LED flashes.
Main rotor continue to spin after
4
landing.
Motor fails to run, but servo moves.
5
Main rotor spins but unable to take
6
off.
Strong vibration of helicopter.
7
Tail still off trim after tab adjustment,
or inconsistent speed during
left/right pirouette.
8
Helicopter unable to remain
stationary during hover.
9
Unusual vibration of helicopter
during flights.
10
If the problem is still there even after tried above, stop flying and contact with your seller.
Cause
Unable to bind to transmitter.
1.Power to transmitter and receiver.
2.Check transmitter and receiver
voltage.
3.Poor contact on battery terminals.
Helicopter battery depleted.
The aircraft did not receive a stop
order.
Loose motor connection or
damaged motor.
1.Deformed main blades.
2.Helicopter battery depleted.
1.Deformed main blades.
2.Bent main shaft.
3.Defomned tail roto.
4.Overighening of main blade greps.
1.Damaged tail rotors.
2.Damaged tail drive motor.
3.Helicopter was not stationary
during power up.
4.Vibration induced gyro iterference,
causing tail unable to lock.
1.Bindling caused by rough
components.
2.Overtighterning of mlxing arms.
1.Binding between maln blades and
blade grips.
2.Insufflcient head speed due to
dlepletion of helicopter battery.
- 24 -
Way to deal
Repeat the power up initializing
process.
1.Turn on transmutter and ensure
helicopter battery is inserted
properly.
2.Use fully charged batteries.
3.Re-seat the battery and ensure
good contact between battery
contacts.
Fully charge the battery, or replace
with a fully charged battery.
Keep down the throttle until it
stops.
Re-seat the motor plug or replace
the motor.
1.Replace main blades
2.Charge or replace with a fully
charged battery.
1.Replace main blades
2.Replace main shaft
3.Replace main tail roto
4.Re-tighten main blade grips with
suitable force.
1.Replace tall rotors.
2.Reblace tail drive motor.
3.Re-power the helicopter while
remaining stationary.
4.Refer to symptom 7.
1.Confrm smooth movements of
components and ball links.
2.Losen up mixing arms axial
screws.
1.Ensure all head components are
smooth with no binding.
2.Replace with a fully charged
battery.