Stop Position Adjustment; Motor Left / Fabric In Front And Motor Right / Fabric Back - AV Stumpfl LS 40 Handbuch

STOP POSITION ADJUSTMENT

MOTOR left / FABRIC in front
and MOTOR right / FABRIC back
LOSS of WARRANTY
The projection screen is properly adjusted at factory and the
adjusting screws are sealed.
Changing of the minimum or maximum final position is not
necessary.
Important: Any damage caused by the adjustment of final
positions is not covered by warranty.
Note: Should it be necessary to adjust the final positions by
applicational reasons, only skilled personnel is allowed to do
so.
Do the adjustment in small steps (one-quarter turn) and
check the result by unwind and rewind the fabric completely.
Adjustment of the final position MAX:
Remove the plastic cap on the bottom side of the
projection screen. (see sketch MAX)
To set the final position MAX higher, turn the
adjusting screw slightly to the right (clockwise).
(see sketch MAX)
To set the final position MAX lower, turn the
adjusting screw slightly to the left (anti-clockwise).
CAUTION:
Do not allow the screen to go beyond the STOP-limit !
Adjustment of the final position MIN:
Remove the plastic cap on the bottom side of the
projection screen. (see sketch MIN)
To set the final position MIN lower, turn the
adjusting screw slightly to the right (clockwise).
(see sketch MIN)
To set the final position MIN higher, turn the
adjusting screw slightly to the left (anticlockwise).
CAUTION: Do not allow the batten to be pulled into
the screen casing !
15