Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TAKE DOWN
■ Make sure all children exit the
product.
■ Makes sure the product is free
from foreign objects.
■ If there is water inside the
seams after using the water pool
keep the air blower at work for
about 30 minutes to dry that out
before packing.
■ Turn the blower(air pump)
power switch to OFF.
■ Unplug the blower(air pump)
power cord.
■ Loosen the Velcro and detach
the inflation tube from the
blower. The product should
F
I
06
deflate on its own within 5
minutes.Make sure the product
is entirely deflated. (refer to
picture F) Remove ground
support stakes.
■ Fold the product in half from
both ends, and then fold it in
half 2 more times from both
sides, vertically to the first
fold.(refer to picture G,H,I)
Roll it up tightly from the end
opposite the inflation tube.
(refer to picture J,K)
■ Slip the carry bag over the
folded product and stakes
(plastic balls or water bags ). Zip
the bag.(refer to picture L)
G
H
J
K
L
MAINTENANCE
• Checks and maintenance of the
main parts of the toys should be
carried out of regular intervals, if
these checks are not carried out,
the toys could overturn or
otherwise become a hazard.
Whenever practical, the
instructions shall also be affixed
to the toy.
• The seasonal inspection and
maintenance should be
REPAIR
In case of any breakage of
product, please patch up through
hand sewing. Each type of
product is provided with a repair
kit which includes six pieces of
cloth( two pieces for each color ).
• Turn off the air blower and
deflate the product.
• Thread a needle with a spare
thread and tie a knot at its end.
• Close up the broken cloth and
sew along the gap. Tie a knot
after sewing to avoid the loose
thread.
In case of cloth breakage(as
shown in picture M ). please
cover the breakage with a piece
of patching cloth of proper size.
conducted for any damage or
leakage of the product.
• The product can be wiped
clean with a mild detergent.
Keep water away from the
blower(air pump) at all times.
• Do not store the product when
wet. Store the product and the
blower indoors in dry conditions
when not in use.
Threads and sewing needles are
not provided and you should
purchase by yourself (3# sewing
needle is suggested).
Then sew up the patching cloth
along its sides.
While repairing, you should take
notice that the sewing should
only occur on the surface layer
of the original cloth rather than
reaching its underlayer.
• In case of breakage in the
seam position (as shown in
picture N), the sewing should
only occur between the two split
cloths rather than reaching the
underlayer or any other cloth.
07
Werbung
