Costway NP10363-6 Bedienungsanleitung Seite 2

SET-UP
● Check the ground where the
product will be set up for any
sharp objects or debris. Do not
install the product over concrete
or any hard surface.
● Place the product on a soft
level surface at least 2 meters
from any structure or obstruction
such as a fence, garage, and
house, overhanging branches,
laundry lines or electrical wires.
● Ensure the play area is free
from hazards such as furniture,
walls sharp objects, other hard
surfaces, etc.
● Set up the product away from
water and any potential fire
hazards.
● Keep the blower (air pump)
and power cord away from areas
of water and moisture. lf water
contacts the blower(air pump),
unplug the blower(air
pump)power cord. Do not
operate until the blower is
completely dry.
● Remove the product from the
carry bag. Ensure the slide cover
coming with the product is
stretched well from top to end.
Be sure to place the product as
close to the power source as
possible.
● Stretch the inflation tube and
attach it to the end of the
blower(air pump). Ensure the
inflation tube is securely
04
attached and in good condition.
The inflation tube should be
straight and untwisted.
Reposition the blower(air
pump)if necessary.) If the
product comes with water bags,
please follow the
undermentioned instruction.
Otherwise, overleap this point.
Spread out the product, place
and fasten the empty water bags
on the two sides of the product.
Open the stopple and fill water in
the water bags until 80%
fl(about 22kg),push and close
the stopple. Make sure water
bags are firmly attached to the
product and no water leakage
before the product is fully
inflated, and never allow children
to play on the slide without
installing a water bag. (refer to
picture A)
● Push ground stakes through
blower base holes. You may need
to use a hammer for proper
placement. Make sure the
blower(air pump)power switch is
in the OFF position. Ensure the
power connections are safely
sited and tripping hazard is
minimized.
● The blower(air pump)should be
securely sited and affixed to the
ground before use. Plug the
blower(air pump)into an
approved ground outlet.
● Ensure the blower(air pump)is
free from debris and securely
sited to avoid tipping.
● Turn the blower (air
pump)power switch to ON. The
continual air-flow blower(air
pump)must be left ON at all
times while the product is being
used.(refer to picture B)
● The product should be fully
inflated.
● Ground support stakes are
used for lawn ground surfaces.
Hook and ft each provided
ground stake through each loop
in the bouncer. To prevent
overturn or lift during playing,
push stakes firmly into the soil.
Make sure the hooked end of the
stake is over the loop at all
times during use. The stakes
should be placed level with or
under the ground to reduce
tripping hazards. (refer to
picture C)
● Please check the age
A B
D
recommendation and user
weights(printed on the product).
You must not exceed the total
weight for the product.
● Put the included play
accessories if any for playing
into the product.(refer to picture
D,E)
● If the product comes with
support cushions at the sides, do
not stand or sit on the cushions.
Hint: Air leak from the seams is
necessary because the product
is inflated by constant airflow
and this leakage is required to
stop the product from becoming
over-inflated.
Hint: It is drawn the user's
attention to the orientation of
inflatable equipment installation
to the sun. The sliding surface of
the product shall not face the
sun as sunshine can glare the
children's eyes when they are
sliding down along the slide.
C
E
05