hillvert HT-TM-200 Bedienungsanleitung Seite 10

Operation
1. Unzip the mesh barrel and load the plants onto it.
2. Zip up the mesh barrel and begin to tumble it.
3. When the trimming is done, open the catch bag's zipper and dump out the debris and then
zip it up.
4. Open the mesh barrel and dump the well-trimmed plant into the catch bag.
Cautions
1. Make sure the product is completely dry on the outside. 5% to 10% moisture on the inside of
the bud is good. Take the large leaves and stems off. The more you prep your bud, the faster
the trimming will occur.
2. Put the RIGHT AMOUNT of product in the net- between 3/4 lb. and 1 pound. The ideal
amount is to fill the barrel to about 2" under the axle. Over filling or under filling are not
recommended. Following these guidelines is critical to the effectiveness of the trimmer.
Once tumbling, the bud should have a nice rolling wave under the axle.
3. Do not over tumble: You may be done after 3 minutes. Stop tumbling every few minutes to
check the progress. You should not need to tumble more than 5-7 minutes. If you do, your
product is either not dry enough or too fluffy.
Cleaning
1. We recommend cleaning the catch bag and dust cover after each use with a damp rag and
resin remover organic cleaner.
2. The mesh nets can be washed in a washing machine with cold water and detergent, line dry
only.
3. Keep your zippers clean and lubricate if necessary
EN