Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Factory reset your smart plug:
Push the reset button on top of the smart plug with a pointy
object for at least 5 seconds until the LED starts pulsating.
IMPORTANT!
• The Smart plug is for indoor use only and can be used in
temperatures from 0ºC to 35ºC.
• Do not leave the Smart plug in direct sunlight or near any
heat source, as it may overheat.
• Do not subject the Smart plug to wet, moist or excessively
dusty environments as this may cause damage.
• The range between the steering device and the receiver
are measured in open air. Different building materials and
placement of the units can affect the wireless connectivity
range.
WARNING:
• Do not connect after each other in sequence.
• Do not cover when in use.
• To disconnect the power, pull the plug.
• Use only indoors in dry areas.
• Do not overload the product.
• Discard the product if damaged.
• For adult use only. This is not a toy and is not intended for
use by children.
Product servicing
Do not attempt to repair this product yourself, as opening
or removing covers may expose you to dangerous voltage
points or other risks.
Get to know your RODRET product
Pairing button
Press to turn on, or long-press to increase brightness
Press to turn off, or long-press to decrease brightness
Changing the battery
A red LED light will blink when you press any button
the dimmer/power switch to show that a new battery is
needed. Open the battery lid and replace with a new AAA/
HR03 battery. We recommend using a LADDA rechargeable
battery. Please note it is sold separately.
Factory reset
To reset and remove all connected products, quick-press the
pairing button 4 times (within 5 seconds). Follow steps 1-3 to
reconnect your smart products.
11
Werbung
