Meec tools 027415 Bedienungsanleitung Seite 50

EN
10 mm of insulation off the end of the
wire and connect it to the other terminal.
The black terminal (B) is the system's IN
direction.
FIG. 3
INSTALLATION OF PERIMETER WIRE
NOTE:
The maximum permitted length for the
perimeter wire is 300 m.
1. The perimeter wire should be laid 35 cm
inside the edge of the mowing area – use
the distance gauge to measure this. It
may be necessary to set the pegs closer
together where the ground is uneven.
FIG. 4
FIG. 5
2. Where the mowing area is crossed by
paths, driveways etc. that are level with
the ground and the mower can travel over
them, the perimeter wire distance can be
reduced from 30 to 10 cm.
FIG. 6
FIG. 7
Protected zones and narrow passages
The perimeter wire can be laid in a loop to
create an island around flower beds, shrubs,
trees, ponds and similar obstacles and zones
where you don't want the mower to go. When
creating an island, the passage for the mower
must be at least 0.8 m wide.
FIG. 8
FIG. 9
50
Corners
Corners should be laid with obtuse angles (90°
or larger) and the perimeter wire must run
completely straight to the corner from both
sides.
FIG. 10
FIG. 11
Slopes
The robot lawn mower is able to climb slopes
up to 27% (15°) without any problem. Avoid
areas steeper than this. Measure and calculate
as shown below.
FIG. 12
CONNECTING THE CHARGING
STATION TO THE POWER SUPPLY
• Insert the mains adapter plug into a
suitable power outlet. If the perimeter
wire is correctly installed, the charging
station status light will be a steady green.
Errors are also indicated by the status
light. See below.
FIG. 13
Status light is off:
­ No power supply. Check that the low voltage
cable is correctly connected to the charging
station and that the cable is correctly plugged
into a suitable and live power outlet.
Steady green light:
­ The perimeter wire is correctly connected
and the robot lawn mower's battery is fully
charged.
Flashing green light:
­ Automatic charging in progress.
Flashing red light:
­ The perimeter wire is not connected. Check
that both ends of the perimeter wire are