Resetting The Device; Troubleshooting - Renkforce CM4216 Bedienungsanleitung

• If you want to cancel the timer function early, press the ON/AUTO/OFF button repeatedly until the LED
indicator lights up blue steadily. After approx. 15 seconds the coffee machine will switch to standby with
all LED indicators being off.
e) Resetting the device
• Disconnect the mains plug for more than 10 seconds from the mains in order to reset all settings.

12. Troubleshooting

No coffee drips from the machine.
• No or not enough water in the water tank. Fill the water tank with water till the minimum marking 0.6L.
• The anti-drip feature is not properly positioned on the glass jar lid. Place the glass jar on the center of
the keeping-warm plate and make sure the anti-drip feature is sitting on the round opening of the jar lid.
• The coffee machine is calcified. Descale the device as described in chapter "14. Descaling".
Device does not start brewing.
• If the LED indicator of the ON/AUTO/OFF button lights up blue, the timer has been activated. Press the
ON/AUTO/OFF button repeatedly, until the LED indicator lights up red in order to start brewing immediately.
Brewing does not start at the pre-set time.
• The clock has not been set correctly. Set the minutes and hours in clock time set mode before using the
timer.
Water drips from the opening on the rear of the device.
• The water tank has been overfilled. Dispose of the excessive amount of water. The water must not
exceed the Max 1.5L marking.
The coffee machine does not turn on.
• The coffee machine is not connected to the mains. Connect it to the mains by plugging the mains plug
into the wall socket.
• The overheat protection mechanism might have been triggered. Disconnect the product from the mains
and let it cool down to room temperature. Then reconnect the product to the mains and switch it on as
usual. If the coffee machine still cannot be switched on, consult an authorized workshop.
29