B) Brewing And Keeping Warm Coffee - Renkforce CM4216 Bedienungsanleitung

b) Brewing and keeping warm coffee

Do not fill the tank with hot water. Only use fresh, cold tap or drinking water.
Never use the coffee machine without water.
Do not fill the water tank beyond the Max 1.5L marking (11), as water will otherwise escape from
the opening on the rear side.
Make sure the keeping-warm plate (14) and the bottom of the glass jar (1) are dry before starting
brewing.
Water steam escapes during brewing. Keep sufficient distance to shelves, walls, and persons.
There is a risk of scalding!
The keeping-warm plate and the glass jar become very hot during use.
Never leave the glass jar empty on the heated plate. Risk of fracture!
• Open the lid (9) of the water tank and fill the water tank (10) with water until the Max 1.5L marking. This
marking must not be exceeded.
• Fill the permanent filter (8) with finely ground coffee; observe the instructions on the packaging. Make
sure the permanent filter is properly installed in the filter holder. Then close the lid of the water tank.
• Place the glass jar with the handle facing to the center front on the center of the keeping-warm plate.
Make sure the anti-drop feature (6) is aligned with the opening of the jar lid (2).
• Press the ON/AUTO/OFF button (D). The LED indicator of that button lights up and the device starts
brewing. Coffee starts dripping. The keeping-warm plate keeps the coffee warm.
You may cancel the brewing process at any time by pressing the ON/AUTO/OFF button two times.
The red LED indicator will then light up blue. After another 15 seconds the LED indicator turns
off. In order to continue brewing, press the ON/AUTO/OFF button once. The LED indicator lights
up red.
If you want to pour a cup of coffee during brewing, briefly remove the glass jar from the device.
The anti-drip feature closes the coffee flow, once you remove the jar from the plate. The brewing
process will not be stopped and the water continues flowing into the permanent filter. In order
for the permanent filter not to overflow, the glass jar must be returned to the keeping-warm plate
within approx. 30 seconds. Make sure the coffee continues to drip into the glass jar.
Please note that the final amount of coffee can be less than the amount of water filled in, as the
coffee powder absorbs part of the water.
• Brewing will be finished once the entire water tank is empty.
• Wait until all the water has passed through the permanent filter and then remove the glass jar by its
handle. Pour the coffee slowly and carefully.
• Coffee will be kept warm for up to two hours. After that the coffee machine will activate standby mode
and the red LED indicator will turn off.
If you want to cancel brewing or keeping-warm earlier, press the ON/AUTO/OFF button repeatedly
until the LED indicator lights up steadily. After approx. 15 seconds later the coffee machine will
activate standby mode and the blue LED indicator will turn off.
27