Use And Function; Heat Setting - Heating Period; Service, Storage And Care; Remote Control - Lenz Lithium Pack Insole Rcb 1200 Bedienungsanleitung

STANDBY:
• The heat setting display (Fig. 1.2) briefly flashes at an interval of 2.5 seconds.
• The battery packs are in stand-by and can be activated with the control button of the battery packs (Fig. 1.3),
via the Lenz HeatApp (Smartphone) or via the remote control (available as an accessory).
IN USE:
• The battery pack supplies the connected Lenz insole with energy and the LED of the heat setting display or
the operating mode display (Fig. 1.2) is illuminated.

USE AND FUNCTION

Turning on/off:
Briefly (approx. 1 sec.) press the control button (Fig. 1.3) to turn on the battery packs at the lowest heat level.
Changing the heat setting:
• Use the control button (Fig. 1.3) to set 3 different heat settings.
• Every time you push the control button (Fig. 1.3), the heat level rises.
• The respective heat setting is indicated by the flashing of the heat setting display (Fig. 1.2) on the battery
packs.
LED flashing – Standby
LED steady on – low heating power
LEDs steady on – medium heating power
LEDs steady on – high heating power
If there is no sole or charger connected to the battery packs, the battery packs will automatically switch
to POWER OFF mode after 12 hours!
(If you are using the Lenz Heat App* to control your battery packs remotely, the app must also be closed on your
smartphone in order for the battery packs to be able to successfully switch to POWER OFF mode.)

REMOTE CONTROL

The lithium pack insole rcB1200 battery packs can be controlled via Smartphone Lenz HeatApp* or via
RemoteControl. The batteries must be in "Pairing Mode" to be able to couple them properly with the Smartphone
or the RemoteControl.
– 70 –
Pairing Mode
Please switch the desired batteries to "Pairing Mode". For this purpose, push the control button
(Fig. 1.3.) for approx. 10 seconds until the heat setting displays (Fig. 1.2.) are blinking and then immediately
release the control button. The heat setting display in the middle is flashing constantly.
LED steady on – Pairing Mode
Note: The Pairing Mode remains active for 2 minutes! If no pairing takes place during this time, this
mode will end automatically!
*The optional Lenz HeatApp (paid app) and Lenz HeatApp Basic (free app) convenient control apps are
available via the Android Play Store and the Apple Store.
Requirements for using the Lenz HeatApp / Lenz HeatApp Basic:
Bluetooth SMART Ready, Android Version 4.3 or higher or iOS Version 7.0 or higher

HEAT SETTING - HEATING PERIOD

The heating period for the heating power level is indicated in the following table for your information.
Heat setting lithium pack insole rcB 1200
1 16 – 22h
2 7 – 10h
3 3 – 4h
The heating period per charge depends on the selected heat setting, the ambient temperature and the
charging status as well as the age of the batteries.

SERVICE, STORAGE AND CARE

To ensure a long life, we recommend storing the battery packs in a cool room (at temperatures ranging from 5°C
/ 41°F to 20°C / 68°F) in a semi-charged status. The battery packs must be turned off (heat setting display (Fig.
1.2) dark) and disconnected from the heated sole and charger for storage.
For long-term storage, we recommend discharging and recharging the battery packs halfway at least every
6 months. This ensures that the maximum battery power is preserved for many years!
Clean the parts as needed with a soft, slightly damp cloth and a mild detergent.
– 71 –