Marzhauser Sensotech PROFILER SCD Betriebsanleitung Seite 166

Operation
6.7.7 COM (Data / Interface)
In the menu COM (Data / Interface) you can configure the se-
rial PC interface of the PROFILER SCD and enable/disable the
button
NOTICE
Faulty data transmission and measurement from incorrect
configuration.
When the PROFILER SCD and PC are connected to each other
over the RS-232 interface, you must enter the same baud rate
selected on your PC when configuring the PROFILER SCD.
Communication
166
.
select baud rate
Note: The baud rate selection is only
relevant for an RS-232 connection to
your PC. With a USB connection, the
baud rate selection has no effect.
Operating Manual