Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Programming the CD Player
The programming of the CD player should be done during STOP mode.
1. Press the PROG button, the LED display will show ' 01 ' and flash continuously.
2. Press the
or
3. Press the PROG button again to store this track in memory, the LED will show ' 02 ' and
flash continuously.
4. Repeat steps from 2 to 3 to store more tracks in memory. You can store up to 20 tracks in
the memory.
5. Press the
button to play the disc in the programmed order.
6. To stop playing, press the STOP
7. To cancel the programming list, press the STOP
FUNCTION switch to OFF position.
1. Switch the unit into CD mode and connect the AUX In cable (not included) to AUX In jack;
The unit is switching in AUX mode.
2. Start playback and change the volume level on this item or External Music Device separately
Important Note
Automatic standby switching
To comply with the ERP2 directive, the unit automatically switches to standby after approximately
15 minutes without a signal.
To switch the unit on again, put the FUNCTION switch in OFF and again in ON position
The current instruction manual can be downloaded from www.soundmaster.de
Technical changes and misprints reserved.
Copyright by Woerlein GmbH, 90556 Cadolzburg,
Duplication only with the permission of Woerlein GmbH
buttons to select the desired track.
button.
AUX
SCD1400 / English Instruction Manual
button and open the CD door or set the
www.soundmaster.de
3
Werbung
