Operation - Panther Fluid Head T 10 Betriebsanleitung

Manual | English
4.

Operation

4.1 Levelling the fluid head
1. Apply the vertical brake and hold the camera
with one hand.
2. Open the clamping screw of the fluid head and
move the head until the bubble moves into the
level's black circle.
ATTENTION !
Tighten the clamping screw firmly.
NOTE:
The PANTHER Fluid Head – T 10 is equipped with a very accurate levelling bubble. If you
are panning, and the bubble is slightly moving out of the marking, it has no negative in-
fluence on the picture.
4.2 Mounting the camera and/or plate
The PANTHER Fluid Head – T 10 is delivered with
the a camera
1. Apply the horizontal and vertical brake.
2. Pull the locking lever to the position "off".
3. Move the locking lever as far as possible to
the right and take out the camera and/or
plate.
4. Attach the camera plate to the tripod adaptor
plate (camera accessory) around the camera's
centre of gravity.
5. By mounting the camera and/or plate again
quick locking
the
cally and the locking lever will audibly snap
back into its initial position.
quick locking
system.
system will lock automati-
3 / 12