Sharp CP-SS30 Software-Upgrade-Anleitung Seite 3

ENGLISH
Does my device need an updated
fi rmware?
To check if your device can benefi t from the update, please check the serial
on the main unit or the product box.
Only devices described in the section "How to check the serial number"
require the update.
If your serial number has a diff erent number to the one highlighted, you
will not need to apply the update.
This update applies to both black and brown models.
What changes are included in the update?
• Resolves the issue that was causing removal/ cutting of the fi rst 0-1s of
audio playback.
• Decrease brightness of the LED so there is less disturbance at night/dark
conditions.
• The previously used volume level and the last used source will be preser-
ved after the unit is turned off .
How to check device version number?
Locate the product serial number label at the back of your device or on the
product box, it should look like this:
CP-SS30BKV01600275212 00001
If the product serial number contains the digits "600275" in characters
13-18, then your device will benefi t from the update.
If the product serial has a diff erent number in characters 13-18, then your
device won't benefi t from the update.
How to prepare USB fl ash drive?
• Prepare empty USB fl ash drive, (capacity= 64GB max, fi le format= FAT32).
• Download the fi rmware fi le from "https://www.sharpconsumer.com/
audio/cpss30bk/" website on to your computer.
File name "CP-SS30 Software update"
• Unzip the fi le and copy the extracted fi le to the root directory of your
USB fl ash drive.
• Ensure that USB fl ash drive has only one fi le: "fw5000.upd".
How to upgrade the fi rmware?
1. Connect the bookshelf speaker to a power source and switch it on.
2. Change source mode to USB (follow the instruction manual).
3. The LED at the front of the bookshelf speaker will turn purple.
4. Make sure that there is only one fi le on the USB. Insert the USB into the
USB port on the back of the bookshelf speaker.
5. The bookshelf speaker will give an audio prompt confi rming the USB
has been plugged in and the LED will turn white once the update
process begins.
6. After a while (approx. 10s) the bookshelf speaker will enter standby
mode and the LED will turn red. Please wait a further 15 seconds before
the next step.
7. You can now safely remove the USB drive from the back of the
bookshelf speaker and turn on the unit.
IMPORTANT:
Please DO NOT turn off the power or remove the USB while the unit is
updating.
LINE
1