Operating - Yolco Rl80D Bedienungsanleitung

Changing door opening direction cont.
8. Unscrew the door handle and screw it
in on the opposite side of its upper edge.
9. Put the mounting plugs in the remaining holes in the upper edge of the door.
10. Slide the upper door into the upper hinge.

6. Operating

Operating the device from control panel
Temperature
increase button
Button Function
Pressed once will turn on/off the device
Device on/off button
Press and hold for 3 seconds to activate night mode.
Temperature increase Buttons responsible for setting the temperature inside the device.
button
A single press
Temperature reduction
A single press
button
Pressed once will change the active compartment
Settings button
Press and hold to change between car battery protection modes (when powered from a 12 / 24V socket
in motor vehicles):
When connecting the device to the application via Bluetooth:
Pressed once, when the "AP" message appears on the device control panel, will enable connection
with the application on the external device.
Changing the temperature scale on the control panel (°C/°F)
With the device turned off, press and hold the button
until the content of the message changes to E5. Use the button or
off the device using the button
Operating the device from the application level (Android / iOS)
The application Yolco can be downloaded from the GooglePlay store (for Android devices) or AppStore (for iOS devices). For the
proper operation of the application, it is required to turn on the Bluetooth function and the location function on the external device.
To connect to the application, launch it on an external device (smartphone / tablet), search for and select the fridge from the list of
available devices. The refrigeration appliance control panel will display "AP", which must be confirmed by pressing the button
The device should be ready for receiving commands from the application.
Restore the device to factory settings
With the device turned off, press and hold the
Then press and hold the
Temperature
decrease button temperature(°C)
inside the
29L compartment
increases the temperature
lowers temperature
(high protection) /
to save the setting.
button until the E1 message is displayed.
and buttons simultaneously until the device turns
12. Slide the lower door into the center hinge.
13. Check that the appliance door closes smoothly. If you encounter
any resistance, check if the bottom Hinge is not bent or over tightened.
Night mode
indicator
Current Current
temperature( C) °
inside the
51L compartment
(medium protection) /
until the message E1 appears. Then press the button several times
to switch between the ° C and ° F temperature scales. Turn
11. Insert the center hinge into
the hole of the center strip.
Settings Device on/off button
button
(low protection).
.