Assembly Process - Yolco Rl80D Bedienungsanleitung

5. Directions for use cont.
• During installation, make sure there is sufficient space on the top (50mm), back (50mm) and sides of the unit (20mm). Ensure free airflow behind the
device. Ensure free airflow behind the device. The recess should have a ventilation opening with a minimum surface of 60cm2.
min
50
mm

Assembly process

1. Connect the power cord to the device.
2. Slide the device into the recess, making sure the power cord is not damaged.
First run
Carefully!
Wait about 6 hours before using the device for the first time.
1. Connect the device to a power source using the supplied cables.
2. Turn on the device and set the temperature to 17°C in both compartment. Wait an hour.
3. If the refrigerator is cooling, you can start using it.
Changing door opening direction.
To change the door opening direction:
1. Take all the products out of the appliance
2. Gently place the device in a horizontal position - with the door facing up
3. Remove the lower door hinge and the base on the opposite side.
Then slide the lower door down.
5.Unscrew the upper door hinge and screw it in
on the opposite side of the control panel strip.
min
60
cm²
min
50
mm
min
60
cm²
min
60
cm²
min
60
cm²
min
50
mm
min
60
cm²
6.Unscrew the control panel
strip cover and screw it in
on the opposite side.
7. Remove the mounting hole
plugs from the top edge
of the door.
min
60
cm²
min
50
mm
min
60
cm²
4.Remove the center
hinge of the center strip.
Then remove
the upper door.
min
60
cm²