Menu 2. - Software Update Via Dmx; Menu 1. - Fixture Configuration - Mbnled Rgb Dmx Controller Bedienungsanleitung

UP/DOWN - language selection
ESC - exit, if there was any modification the controller will ask saving it.
MENU 2. – SOFTWARE UPDATE VIA DMX
There are some products with DMX input available from the manufacturer. The software of these
devices can be updated via DMX link. In this menu you can send an update file form memory (loaded
into the controller from a PC via USB cable) to another device via DMX network.
In upper line is displayed, which software is currently in the memory and at the end of row the version
number is indicated.
Plug in the device, press ENTER and during update you can read on display: software update in
process.
ENTER - start software update
ESC - exit
MENU 1. – FIXTURE CONFIGURATION
Here you can set all parameters for the fixture you want to control.
FIXTURE SELECTION
Up to 8 fixtures can be controlled at same time. To set its parameters, the device has to be selected
first.
UP/DOWN - select fixture (1-8)
ENTER - go in selected fixture parameter setting
ESC - exit to menu
MAXIMUM CHANNEL NUMBER
The maximum channel number can be up to 24. On the data sheet of connected device can be seen,
how many channels the fixture requires. Enter this number here.
For example: if you want to control RGB dimmers, set the value to 3.
UP/DOWN - set maximum channel number (1 - 24)
ENTER - go to next data editing
ESC - back to fixture selection
SOFT/HARD SELECTION
The controller is able to control all channels in hard or soft mode. Hard mode means that the channel
value changes immediately to the new value and soft mode means that the channel value changes
continuously to the new value in the selected soft time.
UP/DOWN - select channel (1 - max channel number)
ENTER - from channel select to hard/soft set, or go to next parameter setting
ESC - from soft/hard set to channel select or back to fixture selection
www.mbnled.com
MBNLED RGB DMX Controller
9 info@mbnled.com