Automatic Mode; Display; Grand Master; Black-Out - Mbnled Rgb Dmx Controller Bedienungsanleitung

MBNLED RGB DMX Controller

AUTOMATIC MODE

After starting the controller is in automatic mode.

DISPLAY

GRAND MASTER

Limits the channel values. The output brightness can be set between 0% and 100%.

BLACK-OUT

By pressing this button the B.OUT effect will be activated and preprogrammed values can be seen on
the output until pressing the B.OUT button again.

MUSIC

When the MUSIC effect is activated, the running chaser will be controlled by a built in microphone.

BPM

The chaser beat can be affected by tapping the BPM button several times.

SLIDER/SPEED

The sliders 1-3 have two different modes. Normally you can change the channel values, but after
pressing SLIDER/SPEED buttons you can modify the chaser parameters: speed, rate and delay.

FUNCTION BUTTONS 1-8

Only one of the FIXTURE, CHASER, COLOR, and MODE buttons can be active at a time.
If the fixture button is active, then fixtures can be selected with button 1-8.
If the chaser button is active, then chasers can be selected with button 1-8. By pressing the chaser
button several times, you can select the chaser banks. There are 3 chaser banks and every bank has
8 chaser, so 3 x 8 = 24 chaser can be created.
If the color button is active, then previously defied colors can be called with button 1-8.
If the mode button is active, then the slider banks can be selected with button 1-8.
www.mbnled.com 11 info@mbnled.com