FUNCTION GROUP BUTTONS (FIXTURE, CHASER, COLOR, MODE/CH)
FIXTURE
After pressing this button you can select fixture 1-8 with the function buttons. If its LED is blinking, the
channels are in manual mode. If you press the button again, the manual selection will be deleted and
blinking stops.
With slider 1-3 only the channels of selected fixtures will be modified.
CHASER
After pressing this button you can select chaser 1-8 with the function buttons. You can change the
chaser bank by repeated pressing. There are 3 banks, so you can run 3 x 8 = 24 chasers. Only one
chaser can be activated at the same time. If one of the LEDs 1-8 is not lit, no chaser is saved on this
button.
Saving a chaser scene:
•
Press the FIXTURE button to go fixture selection
•
Select the fixtures with button 1-8
•
Change the channel value with slider 1-3
•
Press the CHASER button to go chaser selection
•
Press and hold the CHASER button again
•
Press button 1-8 to save the scene (it will be the first step)
•
Change the channel value again with slider 1-3
•
Press and hold the CHASER button again
•
Press button 1-8 to save the scene (it will be the second step)
•
You can save up to 33 scenes per button.
Deleting a chaser:
•
Press the CHASER button to go chaser selection
•
Press and hold one of the buttons 1-8 with the chaser you want to delete
•
After 3 sec the chaser will be deleted, and its LED turnes off.
COLOR
After pressing the COLOR button you can select preset colors with function button 1-8.
•
Press the FIXTURE button to go fixture selection
•
Select fixtures with function button 1-8
•
Change the channel value with slider 1-3
•
Press the COLOR button to go color selection
•
Press and hold the COLOR button again
•
Press button 1-8 to save the scene
MODE/CH
After pressing the MODE/CH button you can the select fader bank. For each button is assigned to 3
sliders, so: 8 x 3 = 24 channels. You can set the assignment order of the faders in the FIXTURE
CONFIGURATION menu.
www.mbnled.com
MBNLED RGB DMX Controller
12
info@mbnled.com