Ronix RC-5010 Bedienungsanleitung Seite 34

exceeds the preset maximum. The valve should be checked before
each day of use by pulling the ring by hand.
1) Turn the air compressor on and allow the tanks to fill. The compressor
will shut off when the pressure reaches the preset maximum.
2) Turn the air compressor off.
3) Pull the ring on the safety valve to release air for three to five seconds.
4) The ring pin must be pushed back into position to stop the flow so air
at high pressure.
WARNING!
If air leaks after the ring has been released, or if the valve is stuck and
cannot be actuated by the ring, do not use the air compressor until
the safety valve has been replaced. Use of the air compressor in this
condition could result in serious personal injury.
MAINTENANCE
WARNING!
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause product damage.
WARNING!
Always wear eye protection with side shields. Failure to do so could result
in objects being thrown into your eyes resulting in possible serious injury.
32
Air Compressor 50L